Xicom XTU-400K, Operation And Installation Manual

Page: 92 / 189

MNC-0400-001 32 of 54 Revision G
Operation, Rack and Digital HPAs
Setup Menu 3
Setup Menu 3 allows you to:
•
Set the time and date used for alarm and fault recording.
•
Select linearizer, if installed, and adjust phase and amplitude.
•
Select band.
Setup Menu 3, Figure 12 provides access to the Time/Date
Menu, the Linearization Menu, the Calibrate Attenuator Menu,
and Setup Menu 4.
[Softkey 1]— Press to access the Time/Date Menu
[Softkey 2]— If Linearizer is installed, press to access the
Linearization Menu
[Softkey 3]— If HPA is multi-band, press to access the Select
band Menu
[Softkey 4]— Press to access Setup Menu 4
Time/Date Menu
[Softkey 1]— Time value on line to the left of this soft key is the
current time: hh:mm:ss. Press to allow entry of new time.
[Softkey 2]— Date value to the left of this softkey is the current
date: yy/mm/dd. Press to allow entry of new date.
[Softkey 3]— Not used. Value entered for the new value on the
numeric keypad shows up to the left of the soft key. Press
[
Enter ] to accept your entry. Press [ Clear ] to clear your entry.
[Softkey 4]— Back. Return to Setup Menu 3