Xerox WorkCentre 7132, System Administration Manual

Page: 69 / 184

NetWare Installation
Xerox WorkCentre 7132 System Administration Guide 69
NetWare Installation
This section describes the installation procedures to use the machine in a NetWare
environment.
Installation Procedure
The installation procedure is as follows.
Network Communication Setup
Enable the SMB port.
When using IPX:
Set the Netware port to [Enabled] using the touch screen or CentreWare Internet
Services.
When using TCP/IP:
Set the Netware port to [Enabled] using the touch screen or CentreWare Internet
Services. Set the IP address on the control panel or CentreWare Internet Services.
For more information, refer to Network Communication Setup on page 69 .
NetWare Setup
For more information, refer to NetWare Setup on page 71 .
Workstation Setup
For more information, refer to Workstation Setup on page 71 .
Test Print
For more information, refer to Test Print on page 71 .
Network Communication Setup
Use this procedure to set up the network communication parameters of the machine.
At the machine, perform these steps.
NOTE: Keep the SNMP port enabled while you use the machine on the TCP/IP
network.
NOTE: Some of the configuration options for this protocol are only available from the
CentreWare Internet Services. Refer to the CentreWare Internet Services chapter of
the User Guide.
First, enable the NetWare port.
1.
Connect the machine to the network.