![background image](http://html2.mh-extra.com/html/xerox/nuvera-100/nuvera-100_installation-planning-manual_3382809057.webp)
Installation Planning Guide
6- 9
Printer requirements and specifications
Figure 6-5
Printer with inverter feeder/stacker and three feeder/
stackers (top view)
1. Back of printer area
2. Printer
3. Inverter feeder/stacker
4. Feeder/stacker
5. Feeder/stacker
6. Feeder/stacker
7. Front of printer area
Bypass transport specifications
The bypass transport option enables you to add a third-party
finishing device. The bypass transport is installed by your service
representative and remains permanently in place. You should not
attempt to remove or reinstall it. The following is
supported by the bypass transport:
•
Paper size and weight: You can use all of the paper sizes
and weights supported by the printer in the bypass transport.
•
Sheet exit orientation: 1 to N (the same order in which
sheets are fed from the printer), delivered face down.
•
Maximum throughput speed: The bypass transport for the
printer supports throughput speeds of up to 180 ppm (pages
per minute). This rate is based on stocks up to 9 by 14.33 /
229 by 364 mm in length.
•
Sheet exit height: 34 inches / 86 cm above the floor.
Summary of Contents for Nuvera 100
