Xerox 2135DX - Phaser Color Laser Printer, Service Manual

Page: 4 / 199

Users safety summary
Terms in
CAUTION Conditions that can result in damage to the product.
manual: WARNING Conditions that can result in personal injury
or loss of life.
Power source:
For 110 VAC printers, Do not apply more than 140 volts RMS
between the supply conductors or between either supply conductor and ground.
Use only the specified power cord and connector. For 220 VAC printers, do not
apply more than 260 volts RMS between the supply conductors or between either
supply conductor and ground. Use only the specified power cord and connector.
Refer to a qualified service technician for changes to the cord or connector.
Operation of product: Avoid electric shock by contacting a qualified service
technician to replace fuses inside the product. Do not operate without the covers
and panels properly installed. Do not operate in an atmosphere of explosive
gases.
Safety instructions:
Read all installation instructions carefully before you plug the
product into a power source.
Terms on CAUTION A personal injury hazard exists that may not be
product:
apparent. For example, a panel may cover the hazardous area.
Also applies to a hazard to property including the product itself.
DANGER A personal injury hazard exists in the area where
you see the sign.
Care of product: Disconnect the power plug by pulling the plug, not the cord.
Disconnect the power plug if the power cord or plug is frayed or otherwise
damaged, if you spill anything into the case, if product is exposed to any excess
moisture, if product is dropped or damaged, if you suspect that the product needs
servicing or repair, and whenever you clean the product.
Ground the product: Plug the three-wire power cord (with grounding prong) into
grounded AC outlets only. If necessary, contact a licensed electrician to install a
properly grounded outlet.
Lifting the printer: To avoid injury or damage to the printer, use three people to
lift the printer.