Xerox 2135DX - Phaser Color Laser Printer, Service Manual

Page: 35 / 199

22
Phaser 2135 Color Printer
J5 Replace Yellow Imaging Drum J5-Replace Yellow Imaging
Drum
J6 Replace Magenta Imaging Drum J6-Replace Magenta
Imaging Drum
J7 Replace Cyan Imaging Drum J7-Replace Cyan Imaging
Drum
J8 Replace Black Imaging Drum J8-Replace Black Imaging
Drum
1. Install a new drum unit.
2. If a new drum unit has been installed but the print engine continues to ask
for a new drum unit, reset the drum unit life count using the topic
“Consumable count initialization” on page 73.
3. Inspect the spring-loaded drum unit contacts (in a set of three). Ensure
they are clean and move up and down freely. Remove and reseat them, if
necessary.
4. Replace the engine controller board.
J9 Yellow Toner Empty Replace Yellow Toner J9-Yellow Toner Empty
J10 Magenta Toner Empty Replace Magenta Toner J10-Magenta Toner Empty
J11 Cyan Toner Empty Replace Cyan Toner J11-Cyan Toner Empty
J12 Black Toner Empty Replace Black Toner J12-Black Toner Empty
1. Install a new toner cartridge.
2. If a new cartridge has been installed but the print engine continues to ask
for a new cartridge, reset the toner cartridge life count using the topic
“Consumable count initialization” on page 73.
3. Replace the drum unit.
4. Replace the engine controller board.
L0 Load Tray # 1 Size 2 Type 3 Load Tray #, Size Type
1. Load the requested size and type of paper in the tray.
2. Ensure the tray is installed correctly.
3. Inspect and test the paper size sensors and the tray’s corresponding
sensor flags.
4. Replace the paper tray sensor board.
5. Replace the paper tray.
6. Replace the engine controller board.
Printer fault messages
Code Front panel message Service message