Service Guide
105
Electronic boards
System controller board
Warning
Switch off the power and disconnect the power cord.
1.
Disconnect all cables connected to the rear of the system controller
board.
2.
Remove the two screws securing the system controller board to the
printer.
3.
Slide the system controller board out to the rear of the printer.
Reverse these steps to install the system controller board. Transfer the RAM
DIMMs and the hard drive from the old board to the new board.
.
Removing the system controller board
0725-23
Summary of Contents for 2135DX - Phaser Color Laser Printer
