Xeda International CEDAX ELECTROFOG EWV8, Instruction Manual

Page: 21 / 84

EWV
- 19 -
TECHNICAL INFORMATION ELECTROFOG
2.1.a Electrical panel
The electrical panel consists of the following elements:
TEMPERATURA RISCALDATORE TEMPERATURA TRATTAMENTO
RISCALDATORE POMPA
BASSA TEMPERATURA RIARMO DIFETTO ALIMENTAZIONE LIVELLO ACQUA
VENTILATORE DEBIT
POWER
CA
PACITY
POR
TA
TA
3
7 4 11 8
9
1
10
2
5
6
DANGER
The main switch (1) also acts as an emergency stop for the machine.
When the emergency stop is used, the mechanical parts of the machine can quickly reach very high
temperatures. To avoid fire hazards, immediately remove the device from the storage room and monitor
the machine until all elements have cooled down.
1. Main switch/Emergency stop.
2. Heater temperature thermostat (heating element
temperature).
3. Treatment temperature thermostat (atomised
output).
4. Yellow indicator light for insufficient water level in the
tank.
5. Reset button. When the indicator light is on, it
indicates stand-by for reset.
6. Fan switch.
7. Heating unit switch.
8. Yellow indicator light indicating power failure.
9. White indicator light indicating product or heating
element temperature too low.
10. Pump flow adjustment potentiometer
11. Pump switch.
ATTENTION
In the event of a defect or excess temperatures,
the safety system is activated, thus blocking the
pump, heating element and injecting water to cool
the machine.
The indicator light on the button (5) lights up to
signal the fault.
Once the causes behind the fault have been
resolved, press the button (5) to reset the machine.
ATTENTION
The machine cannot be reset when there is
insufficient water (indicator light 4 on).