Xeda International CEDAX ELECTROFOG EWV8, Instruction Manual

Page: 28 / 84

EWV
- 26 -
SAFETY ELECTROFOG
3.2.a Work clothing
During application and cleaning of application equipment:
Eyes/face
wear a visor.
Skin protection
wear protective clothing: a combination of cotton fibre or
synthetic type (category III, EN 13034 type 6). Wear an
apron or Class III apron (partial PPE) and PB (3) to be
worn over the above combination.
ATTENTION
Do not reuse contaminated clothing without
washing it first.
Hand protection
use gloves approved according to EN 374-3 in nitrile
or neoprene. Follow the manufacturer’s instructions
and information about protective gloves and their use,
storage, care and replacement.
Respiratory protection
wear a protective respirator with type P3 filter-assisted
ventilation (Category III EN 13941 and EN 12942,
marked A2P3)
Instructions for use of PPE:
Before putting on PPE, you must check the conditions of
the PPE and the different expiration dates.
Before treatment : put on gloves and respiratory
protection equipment. Cover the gloves with the
combination.
After treatment :
- Remove the respiratory protection device, remove
the filters and close them each with the cap, place
the filter in a sealed package. Clean the respirator,
check the battery charge level.
- Wash the gloves, avoiding contact with the outer part,
then store them dry, if intact, or throw them away if
worn or damaged.
- Remove the glasses, store them, if intact, or throw
them away if worn or damaged.
- Remove and discard the apron.
- Wash your hands and take a shower.
Disposal:
Place used PPE in a dedicated container and dispose
of it in an approved collection centre as required by law.