Xantrex 807-1055, Owner'S Manual

Page: 10 / 58

viii Freedom HFS Owner’s Guide
Precautions When Preparing to Charge
• Make sure the area around the battery is well ventilated.
• Make sure the voltage of the batteries matches the output voltage of
the inverter/charger.
• Be careful to keep corrosion from coming into contact with your eyes
and skin when cleaning battery terminals.
NOTES:
• Study and follow all of the battery manufacturer's specific precautions,
such as removing or not removing cell caps while charging, whether
equalization is acceptable for your battery, and recommended rates of
charge.
• For flooded non-sealed batteries, add distilled water in each cell until
battery acid reaches the level specified by the battery manufacturer.
This helps to purge excessive gas from cells. Do not overfill. For a
battery without removable cell caps, carefully follow manufacturer's
instructions.
Precautions When Placing the Inverter/Charger
Do not install the inverter/charger or any part of its supplied wiring in
engine compartments.
BURN HAZARD
Avoid touching the external surfaces - heatsink may be hot.
• Never allow battery acid to drip on the inverter/charger when reading
gravity, or filling battery.
• Never place the Freedom HFS Sine Wave Inverter/Charger unit
directly above batteries; gases from a battery will corrode and
damage the inverter/charger.
• Do not place a battery on top of the inverter/charger.
EXPOSURE TO CHEMICALS AND GASES HAZARD
Failure to follow these instructions can result in death or serious
injury.
FIRE AND BURN HAZARDS
Failure to follow these instructions can result in death or serious
injury.
Failure to follow these instructions can result in minor or moderate
injury.
RISK OF DAMAGE TO THE INVERTER/CHARGER
Failure to follow these instructions can damage the unit and/or
damage other equipment.
Freedom HFS IC Owners Guide.book Page viii Friday, September 11, 2015 2:54 PM