Würth EWS 10-125 Compact, Manual

Page: 19 / 344

19
Note
Modification of the device or manu -
facturing of additional devices is not
permitted. Such modifications can
result in personal injury or malfunc -
tions.
■
Repairs to the device may only be
carried out by appointed and trained
personnel. For such purposes, always use
original spare parts from Adolf Würth GmbH
& Co. KG. This is to ensure and maintain safe
operation of the device.
■
Keep out of the reach of children!
General safety instructions
Special safety instructions
a) This electric tool is to be used as a
grinder, sander, wire brush and cut-off
grinder. Observe all the safety instruc-
tions, precautions, illustrations and
data supplied with the device. Failure
to observe the following instructions can result in
electric shock, fire and/or serious injuries.
b) This electric tool is not suitable for
polishing. Uses for which the electric tool is not
intended may result in dangers and injuries.
c) Do not use any accessories that have
not been specifically intended and
recommended for this electric tool.
Just
because the accessory can be fitted to your elec -
tric tool does not mean that it can be used safely.
d) The permissible speed of the attach-
ment used must be at least as high as
the maximum speed indicated on the
electric tool. Accessories that run faster than
permitted can burst and parts may fly around.
e) Outside diameter and thickness of
the attachment used must conform to
the specifications of your electric tool.
Incorrectly dimensioned attachments cannot be
adequately shielded or controlled.
f) Grinding wheels, flanges, grinding
discs or other accessories must fit ex -
actly onto the grinding spindle of your
electric tool.
Attachments that do not fit exactly
onto the grinding spindle of the electric tool rotate
erratically, vibrate very strongly and may lead to a
loss of control.
g) Do not use damaged attachments.
Before every use, inspect attachments
such as grinding wheels for splintering
and cracks, grinding discs for cracks
or severe wear and wire brushes for
loose or broken wires. If the electric
tool or attachment falls down, check
whether it is damaged or use an un-
damaged attachment. When you have
inspected and fitted the attachment,
keep yourself and other persons in the
vicinity outside the plane of the rotat-
ing attachment and allow the device to
run at maximum speed for one minute.
Damaged attachments normally break during this
test time.