PH802 Advanced Configuration Manual
specific host, when it is configured in 255.255.255.0 as the net mask, it explains it is the network
address.
When add this configure, the output rule table will one item, like the below table show:
Then select
，
click the button ”apply”
After submit click
Æ
Æ
, then reboot, the configure will go into
effect, Then only
203.81.177.102 can access the device via WAN port. Other IP won’t have access to the device.
3.4.5 QoS
QoS configure include: QoS Control based on 802.1p for different IP users. The QoS is used to
mark the network communication priority in the data link/MAC sub-layer. IP phone will sorted the
packets using the QoS and sends it to the destination. QoS provides service classes for accessing
traffics in Internet.
Enable VLAN, you need to configure the LAN Setting in Bridge Mode.
Configure VLAN ID, range from 0 to 4095.
Configure the 802.1P value.
Enable Diffserv, so it will ensure the priority of the data transfer.
Configure Diffserv value.
Note:
you need to set your IP PHONE work in bridge mode to make VLAN function work and
make sure your PC and PH802 in the same VLAN, otherwise your PC will have no access to
PH802.
Wuchuan Network Tech Co., Ltd
www.5111soft.com
15
