Worldwide Construction And Forestry Division 380GLC, Operator'S Manual

Page: 202 / 288

Miscellaneous—Machine
DH10862,0000008 -19-07MAY20-4/4
INSTALLATION—Split O-Ring Seal
1. Apply grease to pins and bores.
2. Align machine arm and link with bucket.
IMPORTANT: Prevent possible machine damage.
Using a larger diameter shim than recommended
does not allow split O-ring seal to seat
properly. Split O-ring seal must seat properly
to keep out dirt and debris.
3. Measure bucket link and arm end play and add shims
(6) as necessary. If multiple shims are used, divide the
shims equally on each side of boom arm and bucket
link.
Specification
Bucket Link and
Arm—End Play.....................................................................0.5—1.5 mm
0.020—0.060 in
CAUTION: Prevent possible crushing injury from
heavy component. Use appropriate lifting device.
4. Use appropriate lifting device to install bucket link pin
and bucket arm pin. See pin weight specification table
for approximate bucket pin weights.
NOTE: Tighten nuts against each other, not against
retainer. Cap screw must be free to turn in hole.
5. Install cap screws and tighten nuts against each other.
6. Install split O-ring seals (10) into bucket link and
bucket arm pivot points as shown. Tighten split O-ring
seal nut to specification.
Specification
Split O-Ring Seal
Nut—Torque....................................................................................6 N·m
53 lb·in
7. Trim excess split O-ring seals retainer cap screw (11)
to specification.
Specification
Split O-Ring Seal
Retainer Cap
Screw—Length.......................................................................10—20 mm
0.394—0.787 in
8. Grease bucket link and bucket arm pivot points.
5— Bucket Boss
6— Shim (as needed) 10— Split O-Ring Seal (4 used)
11— Split O-Ring Seal Retainer
Cap Screw (4 used)
TX1237242A
—UN—12APR17
Split O-Ring Seal
10
6
5
TX1237984
—UN—27APR17
Split O-Ring Seal Correctly Installed
TX1237625A
—UN—19APR17
Measuring Bucket Link and Arm End Play
4-1-17 092221
PN=202