Miscellaneous—Machine
Continued on next page
DH10862,0000008 -19-07MAY20-2/4
INSTALLATION—2MAD™ Seal
1. Install 2MAD™ seals (8) by securing seal with one
hand, sliding fingers under seal, and pulling seal onto
bucket boss (5) as shown.
2. Apply grease to pins and bores.
3. Align machine arm and link with bucket.
IMPORTANT: Prevent possible machine damage.
Using a larger diameter shim than recommended
does not allow 2MAD seal to seat properly.
2MAD seal must seat properly to keep
out dirt and debris.
4. Measure bucket link and arm end play and add shims
(6) as necessary. If multiple shims are used, divide the
shims equally on each side of boom arm and bucket
link.
Specification
Bucket Link and
Arm—End Play.....................................................................0.5—1.5 mm
0.020—0.060 in
CAUTION: Prevent possible crushing injury from
heavy component. Use appropriate lifting device.
5. Use appropriate lifting device to install bucket link pin
and bucket arm pin. See pin weight specification table
for approximate bucket pin weights.
NOTE: Tighten nuts against each other, not against
retainer. Cap screw must be free to turn in hole.
6. Install cap screws and tighten nuts against each other.
7. Slide 2MAD seals from bucket boss into bucket link
and bucket arm pivot points as shown.
8. Grease bucket link and bucket arm pivot points.
5— Bucket Boss
6— Shim (as needed)
8— 2MAD Seal (4 used)
TX1237624A
—UN—01MA
Y17
2MAD Seal
8
6
5
TX1237908
—UN—27APR17
2MAD Seal Correctly Installed
TX1237625A
—UN—19APR17
Measuring Bucket Link and Arm End Play
2MAD is a trademark of ESP International
4-1-15
092221
PN=200
Summary of Contents for 380GLC
