Miscellaneous—Machine
ER79617,0000DD3 -19-19JAN11-1/2
ER79617,0000DD3 -19-19JAN11-2/2
VD76477,00005A0 -19-21JUL17-1/1
Fluid Sampling Test Ports—If Equipped
Hydraulic Oil Test Port
On right side of machine, open engine service door to
access the hydraulic oil test port (1).
1— Hydraulic Oil Test Port
TX1086962A
—UN—19JAN1
1
Hydraulic Oil Test Port
Engine Oil Test Port
On right side of machine, open engine service door to
access the engine oil test port (2).
2— Engine Oil Test Port
TX1086961A
—UN—19JAN1
1
Engine Oil Test Port
Welding on Machine
CAUTION: Avoid potentially toxic fumes and dust.
Hazardous fumes can be generated when paint is
heated by welding, soldering, or using a torch.
Do all work outside or in a well-ventilated area.
Dispose of paint and solvent properly.
When sanding or grinding painted surfaces,
avoid breathing the dust. Wear an approved
respirator. When using solvent or paint stripper,
remove stripper with soap and water before
welding. Remove solvent or paint stripper
containers and other flammable material from
area. Allow fumes to disperse at least 15
minutes before welding or heating.
IMPORTANT: Have only a qualified welder perform
this job. Connect welder ground clamp close to
each weld area so electrical current does not
pass through any bearings, articulation joints,
or pivot points. Remove or protect all parts that
can be damaged by heat or weld splatter.
1. Remove paint before welding or heating.
•
When sanding or grinding paint, avoid breathing the
dust.
•
Wear an approved respirator. When using solvent or
paint stripper, remove stripper with soap and water
before welding.
•
Remove solvent or paint stripper containers and
other flammable material from area.
•
Allow fumes to disperse at least 15 minutes before
welding or heating.
IMPORTANT: Electrical current traveling from
the welder through the machine electrical
system may damage the machine electrical
system, including battery and control units.
Disconnect battery positive and negative
cables before welding on machine.
2. Disconnect the negative (-) battery cables.
3. Disconnect the positive (+) battery cables.
4. Cover, protect, or move any wiring harness sections
away from welding area.
For any repairs, see an authorized John Deere dealer.
4-1-7
092221
PN=192
Summary of Contents for 380GLC
