8
FIGur
1-4 Drone Battery
Battery Pack Specifications:
Battery Capacity: 3S, 5200mAh
Battery Voltage: 12.6V (Fully Charged)
Battery Storage Voltage: 11.4V
Flight Time: 25 Minutes
Battery Level Display:
When the battery is off, press any button on the battery and the
green LED will light up indicating the current battery level.
Please check before each flight to ensure maximum flight time.
Setup of Battery Level Display:
Press the two triangular buttons and hold for 3 seconds to turn the battery
pack on, the green LED lights will turn on and show the battery power level
during flight. Press and hold the buttons for 3 seconds again to turn off.
Charging the Battery Pack:
The battery should only be charged with the supplied World Tech Elite
smart balance charger. Plug the charger into a standard US outlet and
connect the battery to charger with the supplied cable (Figure 1).
Charge until the smart balance charger LED lights up from red to
green (Figure 2).
Charge time is approximately 150 minutes.
Figure 1
Figure 2
Solid Red = Charging
Solid Green = Fully Charged
Flashing = Battery Error
The battery pack should be charged in an ambient temperature of 32 °F to 104 °F.
Notice
The battery packs temperature may be too high after flying. Do not charge the
battery immediately. Charge battery when at room temperature.
Notice
The Raptor Battery Pack is designed specifically for this drone and has a built-in battery level indicator
to easily check battery levels before and during each flight.
Discharging the Battery Pack:
The battery should not be left fully charged for long periods of time. If you are putting the drone into storage
you must discharge the battery to a low level to keep the battery better preserved. To discharge, fly in an
open area and leave in a hovering state until the battery indicator shows only two green lights on the battery.
Take the battery out of the drone during storage.
+
-
+
-
+
-
+
-
+
-
+
-
AA
AA
AA
AA
AA
AA
1-5 Transmitter Battery
The transmitter is powered by 6 x AA Alkaline Batteries. Open the battery compartment cover on back of transmitter,
install the batteries with the correct polarity, then close the battery compartment cover (Figure 1).
Figure 1
Make sure positive and negative
polarities match for all batteries.
Warning
Use the same type and brand of
batteries.
Warning
Do not mix new and used batteries.
Warning
Summary of Contents for raptor
Page 1: ......
