7
1-3 Drone Assembly
(1) Installing the Rotors
(2) Installing the Live Feed Screen
Match the spinning direction noted on each rotor to the correct motor on each arm of the drone (Figure 1).
Attach the rotors by placing on the threaded motor peg on each arm of the drone.
Tighten each rotor nut with the supplied rotor wrench (Figure 2) to secure each rotor to its corresponding motor,
tighten each rotor nut by holding the motor in place and tightening in the opposite direction of the arrow direction
shown for each arm.
Attach the screen holder to the metal transmitter handle (1) and secure with two screws. Lock the screen
holder in place by securing it to the side of the metal handle with the side locking screw (2) positioning
the holder so it is secure before locking in the Live Feed Screen.
Warning
Damaged rotors should only be replaced with official
World Tech Elite Raptor Live Feed Camera Drone Rotors.
Please use the original World Tech Elite rotors only.
Please use the rotor wrench to remove and secure rotor nuts.
Ensure that all rotors are installed correctly and secure before every flight.
Warning
Warning
Warning
Attach the rotors according to
the correct direction on drone
arm and rotor nut.
Rotor nut tightens in the
opposite direction of arrow
shown on top.
Figure 1
Figure 2
Rotor Nut
Motor
Rotor
Wrench
Press and hold the screen holders lock button in (3) and push the Live Feed Screen into place at an angle
until secure and flush with the mount (4), release the lock button. Install the Live Feed Screen antenna by
screwing it into the antenna port until secure (5).
4
5
Summary of Contents for raptor
Page 1: ......
