Work Pro Digiline 8, User Manual

Page: 8 / 36

Digiline 8
1 2
3 4
5
6
7
MIC 1
LINE 1
INPUT 1
+
xA
1. LAN : Allows the unit to an Ethernet TCP/IP network connection
and the integration of up to 255 units on the same network. The
necessary cable for this connection is UTP CAT5.
2. BRIDGE Selector : This dip-switch block activates bridge mode in
the outputs. Dip 1 connects the outputs 1 and 2, dip 2 the outputs
3 and 4, dip 3 outputs 5 and 6, and finally, dip 4 the outputs 7 and 8.
Activating this mode, the BRIDGE LED on the front panel will lit.
(Digiline 8 only) .
3. 1-8 OUTPUTS : This terminal blocks series allow to obtain 150 W
@ 4 in each one. Therefore, it is possible a direct connection to
an adecuate loudspeaker system.
(Digiline 8 only)
4. MIC 1-8 Inputs : Microphone level inputs which incorporate phantom
power (+20V DC) for condenser microphones.
5. LINE 1-8 Inputs : Line level inputs with high signal gain for a direct
connection from a mixing systems or LINE devices.
IMPORTANT : Both input types are balanced.
Each group of LINE & MIC inputs joined
internally,which allows in practice, a 16 virtual
inputs (Stacked inputs).
Each input disposes of an internal LINE/MIC adder.
Incorporating a multiplier factor in order to match the
signals and make a better sum of magnitudes.
6. LMI Input : This level MIC input detects the acoustic
level in the installation in order to adjust automatically
the processed signal.
7.GPIO Inputs : The device incorporates 4 GPIO
inputs (General Purpose Input/Output) with TTL
level (0-5 V DC) for presets triggering from a
wallmount controller.
8. SRL Input : RS 232 interface for external preset
control and interfaces with control devices.
(Digiline MX only)
9. OUTPUTS 1-8 : Balanced outputs of LINE level for
connecting to external amplified systems.
(Digiline MX only)
1
2
3
4
5
5
1. SIGNAL LED : This green color LED lits to indicate the pesence
of the corresponding output signal.
2. LED CLIP : This red color LED lits when the units detects high
peaks on input signal that can produce distortion and reduce
the unit performance. The optimal operation should work with
signal levels that create an occasional LED blink, without to fix
liting.
3. BRIDGE LED : This yellow color LED will lit when the Bridge mode
between two consecutive outputs will be activated.
4. PROT LED : This red color LED lits when the amplifier internal
protections are activated in order to protect the unit. In that case,
turn off the unit and check the installation in search of short circuits.
6. ETHERNET LED : This LED lits when it detects the LAN network
connection in the unit.
7. POWER : This switch allows to power on/off the unit.
5. Volume Control : These potentiometers allow to control the gain on their
respective outputs. Upper potentiometers control odd channels and lower
potentiometers control even channels.
User Manual
DIGILINE Series
Page 6
DIGILINE 8 / DIGILINE MX