Work Pro Digiline 8, User Manual

Page: 10 / 36

1.7. Device Connection
1.7.1. Audio Signal Connection
MIC 1
LINE 1
Balanced input signal
Balanced input signal
(MIC level)
(LINE level)
T
o a loudspeaker
T
o a loudspeaker
system.
system.
Digiline 8
DIGILINE sums internally
both signal applied in the
same input.
DIGILINE series devices incorporate an array of 16 external sources of input
audio (8x2). Therefore,each of the 8 inputs allows the connection as much MIC
level device as LINE level device. These 2 input sources are summed internally,
forming the processing signal of each input.
Input Connection. The insertion of signal in DIGILINE is made through a 3-pin
terminal blocks (as much MIC inputs as LINE inputs), corresponding to a balanced
audio signal (+, GND, -). To do this, a 2 conductors shielded cable should be used
DIGILINE 8 incorporates powered outputs, thus it disposes of different terminal
block ti direct connection to loudspeaker system
DIGILINE 8 output connection
corresponding to the 2 independent
outputs placed in the same
terminal block.
User Manual
DIGILINE Series
Digiline devices
network has DHCP, which will provide a valid IP address to the device.
In the same network must be connected a computer with installed WorkCAD control software.
NOTE : If your network has no DHCP connection, the device will usea local-link IP within 169.254.XX range,
being XX a direction supplied by the device upon its connection to not interfere with other devices in the same network.
WorkCAD software will detect the device for configuration.
NOTE : Each DIGILINE include a stick with MAC information and IP static inside 10.XXX.XX.XX You can connect
it to a computer with the same Subnet using a crossover cable between them.
must be connected to an ethernet LAN using a Cat 5 cable with RJ 45. In this case is advisable that the
IMPORTANT
For a complete DIGILINE configuration, the user requires basic
knowledge management networks and/or the connecting server
administrator permissions.
The device integrating is achieved by connecting it to a node in an Ethernet switch, which allows all devices on the
LAN network interconnection.
IP address assignations is automatic thanks to the DIGILINE device control software through MAC address of the
own device.
1.7.2. LAN Connections
Page 8
DIGILINE 8 / DIGILINE MX