Manual 02007
DSLC Digital Synchronizer and Load Control
Woodward
59
Conclusion of Setup Procedures
This completes the adjustment chapter. Be sure to save the set points by
pressing the “SAVE” key on the Hand Held Programmer. Run through all the set
points and record them for future reference in Appendix A. This can be useful if a
replacement control is necessary or for start-up of another similar unit. Power
down the control for about 10 seconds. Restore power and verify that all set
points are as recorded.
CAUTION—SAVE SET POINTS
To prevent possible damage to the engine resulting from improper control
settings, make sure you save the set points before removing power from the
control. Failure to save the set points before removing power from the
control causes them to revert to the previously saved settings.
Disconnect the Hand Held Programmer from the control.