HM126 Operator’s Manual
ADJUST THE POST SLEEVE BUSHINGS
Once the sawmill head assembly is level, loosen the eight (8) hex bolts (4 top, 4 bottom) just
enough so the bushings can be pushed forwards and backwards. Do this for both sides of the
sawhead.
Push the bushings together (front-to-rear) so that there is no gap between the bushing wear
pads and the front/rear faces of the post as shown below.
With the wear pads flush with the posts, tighten all the hex bolts and spray the posts with a
water resistant silicone lubricant such as “
WD-40 Water Resistant Silicone Spray
” or “
3-in-
One Silicone Spray Lubricant
.”
HM126-MY2021-EN: Rev F
Page
of
62
112
14-Jul-2021
UPPER
LOWER
The bushing side “fingers”
naturally push inwards so as
they wear, continuous pressure
is applied to each side of the
carriage post.
However, the front & rear wear
pads on the bushings do not
self-adjust. As a gap appears
over time due to wear, simply
loosen two (2) bolts on one side
and push the bushing towards
the post until they are flush
again.
The bushing holes are slotted to
allow for this future adjustment.
No
Gap
Gap
Wear Pad
“Fingers”
