HM126 Operator’s Manual
Attach the twelve (12) levelling feet assemblies to the rails at the locations shown below.
Assemble the levelling feet up through the bottom of the rails and thread an M16 hex nut onto
each of the M16 X 120 mm hex bolts. Do not tighten the nut. Leave it loose enough so a
noticeable gap exists between the nut and the rail to allow for track levelling in a later step.
With the feet loosely assembled to the rails, remove the timber/block supports so the full weight
of the track is resting on middle nuts of the levelling feet.
HM126-MY2021-EN: Rev F
Page
of
22
112
14-Jul-2021
Gap
M16 Hex Nut
Remove timbers/
blocks after feet are
assembled to rails
