HM126 Operator’s Manual
SQUARING THE TRACK AND SETTING THE WIDTH
The assembled track measures 30-
½
in [775 mm] wide when measuring from the outside faces
of the rails.
With the bunk hardware connections only snug-tight, the rails can be moved in or out as needed
until the proper width is achieved along the entire length of the track.
When the width is uniform along the full track length, check it for square by measuring
diagonally from rail tip-to-rail tip as shown with the
red arrows
below.
Ensure the end bunks are square to the rails.
Once the width is correct and the track square,
tighten all sixteen (16) M10 X 25 mm and sixteen
(16) M10 X 35 mm flanged hex bolts and their
nuts
working from the centre out towards the
ends
as shown with the
black arrows
above.
Double-check the track width and squareness
after tightening. Readjust if necessary.
HM126-MY2021-EN: Rev F
Page
of
20
112
14-Jul-2021
30-1/2" 775mm
90°
END BUNKS SQUARE TO RAILS
Tighten from centre out
Tighten from centre out
30-
½
in [775 mm]
