SAWMILL ALIGNMENT
Align Side Supports
7
7-14
60HDdoc042607
SAWMILL ALIGNMENT
7.2
Align Side Supports
See Figure 7-14.
Place two square tubes or straight board across the bed rails in front of
one of the side supports. Use the controls to raise the side supports all the way up. Set a
square on the tubes or board and place against the side support. The side support should
be square to the bed or tilted slightly forward 1/32” (0.8 mm). Adjust the tilt of the side
support if necessary.
To tilt the side support forward, loosen the top adjustment nuts and tighten the lower
adjustment nuts. Adjust both sets of adjustment nuts on each side of the side support
evenly. To tilt the side support back, loosen the bottom adjustment nuts and tighten the
top adjustment nuts.
FIG. 7-14
Place square
against side
support
Alignment
Tubes (2)
Adjustment
Nuts
300_0009-7
