SAWMILL ALIGNMENT
Blade Guide Levelling
SAWMILL ALIGNMENT
60HDdoc042607
7-37
7
Blade Guide Levelling
Perform the following steps to make sure the blade guide assembly is parrarel to the
blade.
1.
Loosen the alignment bar mounting bolt. Use the provided adjustment tool to adjust the
alignment bar up so the bar is close to, but not touching the bottom of the blade.
Retighten the alignment bar mounting bolt.
2.
Check that the gap from the alignment bar to the blade is the same along entire length of
the bar. Shine a flashlight behind the blade guide assembly to help you see the gap
between the bar and the blade. To adjust, loosen the rear clamp bolts, but leave snug.
Determine which of the two adjustment bolts to use to tilt the blade guide assembly as
desired. Loosen the jam nut and turn the bolt until the alignment bar is parallel to the
blade. Retighten the jam nut and clamp bolts. Repeat for the second blade guide
assembly.
See Figure 7-36.
FIG. 7-36
600041
Loosen rear
clamp bolts
Check gap between
blade and alignment
bar (See Detail)
Use bottom disk adjust-
ment
tool to raise alignment
bar close
to blade
Outer tilt
adjustment bolts
Blade has
the same distance
from bar along
entire
length of bar
DETAIL
