Maintenance
Miscellaneous
Maintenance
60HDdoc100206
5-7
5
5.6
Miscellaneous
1.
Oil all chains with Dexron III ATF every fifty hours of operation.
CAUTION!
Do not use chain lube. It causes sawdust
buildup in chain links.
2.
Apply a thin film of a NLGI No. 2 grade lithium grease to the blade guide arm every fifty
hours of operation to help prevent it from rusting.
3.
Adjust the blade guide arm drive chain as necessary. To adjust the chain, loosen the
blade guide arm motor mounting plate bolts and slide the motor to take slack out of the
chain.
4.
Grease the clamp mechanism, loading arms and side supports with a NLGI No. 2 grade
lithium grease every fifty hours of operation.
5.
Check the mill alignment every setup (
).
6.
Make sure all safety warning decals are readable. Remove sawdust and dirt. Replace any
damaged or unreadable decals immediately. Order decals from your Customer Service
Representative.
5.7
Drive Belt Adjustment
WARNING!
Never adjust the drive belts and the drive belt
bracket while the motor is running. Failure to do so may
result in serious injury.
Periodically check the drive belt for wear. Replace any damaged or worn belts as needed.
See Figure 5-4.
Using the bolt located between the drive-side wheel covers, adjust the
drive belt tension properly. Turn this bolt clockwise to increase the belt tension,
50
50
AR
50
AR
