Operation
Programming board and cant thicknesses (possible only when REF1, REF2, PAT1, PAT2 or
Operation
doc042607
4-11
4
(i.e. each board being cut, up to the last one, is of the same thickness), he can use
BED REF function (the blue BED REF button on the control panel).
4.2.9
Programming board and cant thicknesses (possible only when REF1,
REF2, PAT1, PAT2 or BED REF is enabled)
The operator can program several thicknesses of boards and cants that will be used most
frequently when sawing in automatic mode (REF1, REF2, PAT1, PAT2, BED REF
functions).
See Figure 4-10.
The control includes five buttons and MEMORY BANK button that can
be used to program board thicknesses. These buttons are: three yellow BOARD THICK-
NESS buttons, located under the display, as well as the blue PAT 1 and PAT 2 buttons
and MEMORY BANK button, located at the right of the display. When you are using PAT1
or PAT 2 function, the selected PAT1 or PAT2 button indicates thickness of the lowest
dimension (cant) the saw will cut. Board thicknesses that will be used until you get this
dimension can be programmed under Board Thickness buttons only. After pushing the
Board Thickness button that stores a desired board thickness, the light located under
this button comes on. When REF1, REF2 or REF LOCK function is on and you select
either of PAT buttons, with a pre-programmed board thickness, this button will illumi-
nate. The active board thickness is always shown on the display. To switch between the
pre-programmed board thicknesses, use the
top button on the right joystick
. By press-
ing the
MEMORY BANK button
you can switch between memory banks (4).
