Operation
REF functions (temporary referencing the blade location)
Operation
doc042607
4-19
4
See Figure 4-13.
Example: The saw head is at the height of 300 mm, the REF1 and REF
LOCK functions are turned on (REF1 and REF LOCK lights are on steady state,
the display reads:
„Ref 1 Lock 300mm”).
The selected board thickness is 50 mm
(the display reads:
„Board 1 50mm”)
.
Push the left joystick away from you and hold it. As long as the left joystick is engaged,
the saw head will be moving down.
When you release the joystick, the saw head will
move to the nearest (below the height at which the joystick was released) multiple
of the
selected board thickness calculated from the last cutting position in REF1.
In this
example the left joystick was released when the saw head was at the height of 180 mm.
Therefore, the saw head will stop at the height of 150 mm (to make the explanation
clearer we assume that the blade kerf is O). If you pull the left joystick toward you and
hold it, the saw head will be moving up. When you, for example, release the joystick at
the height of 420 mm, the saw head will raise to the height of 450 mm (as this is the
nearest - above the height of 420 mm - multiple of 50 mm, calculated from the stored
REF1 height).
FIG. 4-13
Height at which the saw head
will stop if you release the joystick
at the height of 420 mm
while the saw head is raising
REF 1
STORED
HEIGHT=300mm
BOARD THICKNESS=50mm
250mm
150mm
200mm
100mm
450mm
350mm
400mm
300mm
DOWN
UP
Height at which the saw head
will stop if you release the joystick
at the height of 180 mm
while the saw head is lowering
