Setup & Operation
Sawmill Setup
Setup & Operation
15doc121912
3-1
3
SECTION 3 SETUP & OPERATION
3.1
Sawmill Setup
IMPORTANT!
Before starting to use the sawmill you have to meet the
following conditions:
Set up the sawmill on firm, level ground and level the sawmill. Secure the sawmill to the ground to
prevent moving during operation. A concrete foundation or pads (rated to support 31 T/m
2
at each
sawmill foot position) and 16mm anchored bolts are recommended.
Under roof, the sawmill should always be operated with the sawdust collection system.
The sawmill can be operated under roof only.
The sawmill can be operated in temperature range from -15
o
C to 40
o
C only.
The illumination at the operator's position should be at least 300lx.
The sawmill operator’s position is shown below.
Have a qualified electrician install the power supply (according to EN 60204 Standard). The power
supply must meet the specifications given in the table below.
IMPORTANT!
When starting the machine for the first time, check that main
motor rotation direction is as indicated by the arrow located on the motor
body (fan guard). If the rotation direction is incorrect, invert the phases in
the phase inverter in the power socket (electric box). Setting the phases in
the phase inverter correctly will ensure correct rotation directions of all
sawmill motors.
The LT15 sawmills are only partially aligned at the factory. Some assemblies need to be aligned by
the user before first usage of the sawmill.
3-Phase
Volts
Fuse disconnect
Suggested Wire Size
400 VAC
16 A
2,5 mm
2
to length of 15m
TABLE 3-1
!
150189a
!
