SAWMILL ASSEMBLY
Saw Head Assembly
2
2-15
15doc121912
SAWMILL ASSEMBLY
See Figure 2-8.
CAUTION!
The top of the leg should not be higher than the top surface of
the bed rail.
2.5
Saw Head Assembly
1.
Position the saw head at the end of the bed frame assembly. Carefully slide the saw head rollers onto the
bed frame track. Keep the saw head square to the bed to avoid putting the track rollers in a bind.
WARNING!
When setting the saw head on the bed frame, use extreme
care and keep all persons at a safe distance. Failure to do so may result in
serious injury or death.
2.
Position the middle track cover between the two track roller housings so the opening in the cover is
positioned over the feed rope pulleys. Secure with two hex head bolts and lock washers.
3.
Install a track wiper with a felt strip to each track roller housing using a 8.4 flat washer and M8x12 hex head
bolt.
FIG. 2-8
25mm
(1")
150108b
Foot Plate