Maintenance
Replacing the blade teeth
4
4-1
IE
doc122719
Maintenance
SECTION 4 MAINTENANCE
Refer to the motor manufacturer’s manual for maintenance intervals and procedures
regarding the power supply unless otherwise instructed in this manual. Follow the
manufacturer's recommendations for dusty conditions.
IMPORTANT!
This manual only provides information about
additional procedures or procedures to be performed at
different time intervals than found in the manufacturer's
manuals. Refer to the manufacturer's manual for complete
maintenance instructions.
4.1
Replacing the blade teeth
DANGER!
Always shut off the engine and allow all moving
parts to come to a complete stop before removing any
guards or covers. Failure to do so may result in serious
injury.
See figure 4-1.
Replace the blades teeth as necessary. Dull blades teeth will cause the
motor to work harder and will result in decreased cut quality and accuracy. Blades teeth
life will vary depending on maintenance of machine, operator, species of wood being
sawn, and condition of wood being sawn. To remove the blades teeth perform the
following steps:
Unbolt and open the rear top blade guard. Make sure the guard is secure properly.
!
