Setup and Operation
Edging Lumber
Setup and Operation
IE
doc122719
3-15
3
2.
Place the board on the infeed table. Use the provided pivot posts to assist loading if nec-
essary.
See Figure 3-1.
3.
Place the board in the approximate center of the table.
4.
Use the blade adjustment button on the control panel to move the blades as desired. Use
the scale at the top of the edger to determine the width of cut. Again, the lasers show the
path of the blades.
5.
Start the blade motors and the feed motor. Push the board into the edger until the feed
system takes the board.
6.
Repeat the above procedures for all boards to be edged.
7.
Shutdown the machine when done edging.
FIG. 3-1
Blade Scale
Pivot Posts
IE0001-3a
Laser Guides
