Safety
Keep safety labels in good condition.
Safety
IE
doc122719
2-9
2
Activities where guards or electrical panel guard is open or
removed
Maintenance hazards include:
Blade contact
Pinch points
Kickbacks
Missiles (thrown blades/wood chips)
Electrical
Failure to lockout may result in:
Cut
Crush
Blindness
Puncture
Serious injury or death
Amputation
Burn
Shock
Electrocution
To control maintenance procedures:
Lockout procedures must be followed (see ANSI Standard
Z244.1-1982 and OSHA regulation 1910.147).
Never rely on machine stop control for maintenance safety
(emergency stops, on/off buttons, interlocks).
Do not reach into moving blades or feed systems. Allow all
coasting parts to come to a complete stop.
Electrical power supply and air supply must both be locked out.
Where established lockout procedures cannot by used (electrical
troubleshooting or mechanical dynamic troubleshooting),
alternative effective protective techniques shall be employed which
may require special skills and planning.
Always follow safe operation practices in the workplace.
Keep safety labels in good condition.
IMPORTANT!
Always be sure that all safety warning decals are
clean and readable. Replace all damaged safety decals to prevent
personal injury or damage to the equipment. Contact Wood-Mizer
Customer Service or your local distributor to order new decal.
IMPORTANT!
If replacing a component which has a safety decal
affixed to it, make sure the new component also has the safety
decal affixed.
!
