Setup & Operation
Setup
3
3-4
IE
doc122719
Setup & Operation
the edger, clockwise to lower the edger. Retighten the locking bolt.
See figure 3-4.
Assemble the infeed table to the front of the edger with the bolts pro-
vided. Use the height adjustment bolt and nut to support the infeed table properly before
securing the infeed table to the edger on both sides.
Adjust the infeed table height in the same manner as the edger legs so the table is
aligned with the infeed rollers of the edger.
NOTE:
Make sure the infeed table rollers are
leveled with the edger lower infeed drive rollers before starting cutting.
FIG. 3-3
FIG. 3-4
Locking Bolt
Adjusting Nuts (2)
IE0008-2
Adjustment Nuts
(2)
Adjustment
Bolt
1/2-13 x 4 ½ Hex Head Bolt (2)
1/2 SAE Flat Washer
1/2-13 Nylon Hex Lock Nut
Height Adjustment Nut Height Adjustment Bolt
Hex Head Bolt, 1/2-13x4 1/2 (2)
Flat Washer, 1/2” SAE
Hex Nylon Nut, 1/2-13
Height Adjustment Nut
Height Adjustment Bolt
