WolfVision VZ-C6, Instructions Manual

Page: 21 / 60

20
HDMI IN - external input #19 and #20
A computer can be connected to the inputs HDMI IN 1/2 (#19 and #20) of the Visualizer.
By the Visualizer displays the signal from the external input to the audience.
To switch back to the live image of the Visualizer use the LIVE key on the remote control.
Supported resolutions are from VGA (640x480@60Hz) to with several
resolutions and refresh rates in this range. Preferred
Following data are provided:
Plug & Play Monitor VESA DDC
Monitor name: "WolfVision"
Video Input Definition: digital signal
Vertical range limits: 50Hz - 60Hz
Horizontal range limits: 20kHz - 75kHz
Maximum pixel clock: 170MHz
Gamma: 2.2
Preferred resolution: 1080p (1920x1080) @60Hz
pressing the EXT 1/2 key (#39)
(#33)
WUXGA (1920x1200@60Hz)
1080p (1920x1080@60Hz).
Depending of input resolution, black bars are possible.
The Visualizer has a built-in D/A-converter in order to convert the digital signal from the computer and
output it on the RGB and HDMI outputs (inclusive stereo audio) in the selected signal format.
HDMI Content Protection - HDCP
The Visualizer does not support HDCP (High-bandwidth Digital Content Protection).
Encrypted signals on the HDMI IN will be blocked and the Visualizer will output just a black image.
The proprietary HDCP technology is used on protected content like Hi-Definition Hollywood movies and
Pay-per-view transmissions and will not affect non-protected content.
It is not allowed to bypass the security system by law.
Copyright owner is Digital Millennium Copyright Act (DMCA).
In some rooms the built-in infrared receiver of the Ceiling Visualizer may not be enough. In this case
connect the optional external infrared receiver to the IR-sensor plug
(#12) and position the IR-sensor
somewhere on the ceiling (or in the room) where the users normally point the remote control at.
optional: External Infrared (IR) Sensor
19-pin HDMI
connector female
(front side, unit)
19 1
18 2
1 - T.M.D.S. Data2+
2
- T.M.D.S. Data2
8 - T.M.D.S. Data0 Shield 15 - SCL (I²C Serial Data Line for DDC)
Shield 9 - T.M.D.S. Data0- 16 - SDA (I²C Data Line for DDC)
3 - T.M.D.S. Data2- 10 - T.M.D.S. Clock+ 17 - DDC Ground
4 - T.M.D.S. Data1+ 11 - T.M.D.S. Clock Shield 18 - DC+5V (max. 50mA)
5 - T.M.D.S. Data1 Shield 12 - T.M.D.S. Clock 19 - Hot Plug detect
6 - T.M.D.S. Data1- 13 - Reserved
7 - T.M.D.S. Data0+ 14 - ARC (Audio Return)
CEC (Consumer Electronic Control), ARC (Audio Return Channel) and HEC (HDMI Ethernet Channel) are
not supported.