Wolf Drawer Microwave Oven, General Information Manual

Page: 47 / 84

To remove the primary or secondary control board, first
uninstall
the unit . Then remove:
1
Cooktop
2
Glass assembly
Remove the Primary or Secondary Control Board
1 Disconnect the wire harness from the control board being
removed.
2 Use needle-nose pliers to compress the top of the control
board support and lift the control board off of the control
board support.
3 Remove the control board from the cooktop.
PRIMARY OR SECONDARY CONTROL BOARD INSTALLATION
After installing the primary or secondary control board, install:
1 Glass assembly
2
Cooktop
Then
install the unit
.
Install the Primary or Secondary Control Board
1 Press the primary or secondary control board on to the
control board supports.
2 Connect the wire harness to the primary or secondary
control board.
COIL ASSEMBLY REMOVAL
WARNING
Disconnect the product from the power source
before starting this procedure.
To remove the coil assembly, first
uninstall the unit
. Then
remove:
1
Cooktop
2
Glass assembly
Remove the Coil Assembly
1 Use a small flat-blade screwdriver to lift the coil assembly
from the wire side of the coil assembly.
2 Use a T-25 Torx bit or large flat-blade screwdriver to loosen
the terminal screws holding the coil assembly wire
connectors. Remove the wire connectors.
3 Disconnect the negative temperature coefficient (NTC)
sensor.
4 Remove the coil assembly from the generator plate.
COIL ASSEMBLY INSTALLATION
After installing the coil assembly, install:
1 Glass assembly
2
Cooktop
Then
install the unit
.
Install the Coil Assembly
1 Place the coil assembly on to the generator plate.
2 Connect the negative temperature coefficient (NTC) sensor.
3 Place the coil assembly wire connectors on to the terminals.
Use a T-25 Torx bit or large flat-blade screwdriver to tighten
the terminal screws.
30" and 36" Induction Range
Cooktop Component Removal and Installation
service.subzero.com
829191 REVA 47