Wolf Drawer Microwave Oven, General Information Manual

Page: 65 / 84

2 Connect the wire harnesses to the cooling fan. Double
check the HES wire harness connection.
3 Place the cooling fan with the cooling fan bracket into the
unit.
4 Use a T-20 Torx bit to install the cooling fan bracket
mounting screws.
THERMAL CUTOUT (TCO) REMOVAL
WARNING
Disconnect the product from the power source
before starting this procedure.
To remove the TCO, first
uninstall the unit
. Then remove:
1
Back plate
2 Cooling fan
An alternate method to remove the TCO on the Induction
Range, is to first
uninstall the unit
. Then remove:
1 Cooktop
Remove the Thermal Cutout (TCO)
TIP: If doing the Induction Range alternate method, do not
do Step 2.
1 Use a
1
/
4
" socket to remove the thermal limiter bracket
mounting screws.
2 Remove the wire connectors from the TCO.
3 Use a T-20 Torx bit to remove the TCO mounting screws
from the thermal limiter bracket.
4 Remove the TCO from the unit.
THERMAL CUTOUT (TCO) INSTALLATION
After installing the TCO, install:
1 Cooling fan
2
Back plate
Then
install the unit
.
For the Induction Range alternate method, after installing the
TCO, install:
1
Cooktop
Then install the unit .
Install the Thermal Cutout (TCO)
1 Place the TCO onto the thermal limiter bracket.
2 Use a T-20 Torx bit to install the TCO mounting screws into
the thermal limiter bracket.
3 Use a
1
/
4
" socket to install the screws into the thermal
limiter bracket.
4 Install the wire connectors onto the TCO.
30" and 36" Induction Range
Rear Component Removal and Installation
INSTALL THE COOLING FAN (continued)
service.subzero.com
829191 REVA 65