Wolf Drawer Microwave Oven, General Information Manual

Page: 41 / 84

LED Brightness Setting
When entering User Options Mode, one dot is shown on the left
rear power level selector. "Uo" appears on the display.
TIP: The fully illuminated dots in the image are shown larger for
clarity.
The left front shows the current brightness. The brightness
setting from the factory is three out of eight.
•
Touch the left rear (high) to move forward to LED
Brightness.
• Four dots are shown on the left rear power level selector.
"br" appears on the display.
•
Touch the left front (low) to decrease the LED brightness.
•
Touch the left front (high) to increase the LED brightness.
• The LED brightness range is one to eight.
•
Touch the left rear (low) to move backward to Auto-Lock.
•
Touch the left rear (high) to move forward to annunciator
volume setting.
•
Touch to return to the lock setting.
• Not touching the cooktop for 30 seconds returns the
cooktop to the lock setting.
DIAGNOSTIC MODE
Place the cooktop in Diagnostic Mode to access the following:
•
LED Test
• Generator Reconfiguration
• Control Temperature Readout
• Heat Sink Temperature Readout
• Coil Temperature Readout
• Error Code Readout
• Software Version Indicator
To access Diagnostic Mode:
1 Place the cooktop in Lock Mode .
2
Touch and hold and for five seconds. The cooktop
enters Diagnostic Mode.
LED Test
When entering Diagnostics Mode, one dot appears on the left
rear power level selector.
TIP: The fully illuminated dots in the image are shown larger for
clarity.
All LED indicators for all control zones are on. The display, lock,
hot, and boost LEDs are on.
•
Touch the left front (low), or (high), cycles the LEDs
through on, dim, and off.
•
Touch the left rear (high) to move forward to Generator
Reconfiguration setting.
•
Touch to return to the lock setting.
• Not touching the cooktop for 30 seconds returns the
cooktop to the lock setting.
Generator Reconfiguration
When entering Diagnostics Mode, one dot appears on the left
rear power level selector.
TIP: The fully illuminated dots in the image are shown larger for
clarity.
Reconfiguring the generator clears all errors.
•
Touch the left rear (high) to move forward to Generator
Reconfiguration.
• Two dots appear on the left rear power level selector. "CF"
appears on the display.
•
Touch and hold the left front (low) and the left front
(high) for three seconds to start the generator
reconfiguration.
• An acceptance beep occurs when the generator
reconfiguration command is turned on.
• All errors are cleared.
• The cooktop returns to the lock setting.
Control Temperature Readout
When entering Diagnostics Mode, one dot appears on the left
rear power level selector.
TIP: The fully illuminated dots in the image appear larger for
clarity.
30" and 36" Induction Range
Cooktop Controls
LED Brightness Setting (continued)
service.subzero.com
829191 REVA 41