Dual Fuel Range Surface Operation
11
wolfappliance.com
NYLINER
Control knob nyliner insertion.
Surface Burners
CONTROL KNOBS
The control knobs are positioned to correspond to the
burners they regulate. The knobs on the far left regulate
the burners on the left side. Conversely, the knobs on the
far right regulate the burners on the right side.
The precision fit of the control knobs requires the use of
a nyliner inserted between the knob and bezel. When
removing knobs for cleaning, place the bearing back
inside the bezel for easy reinstallation of the knobs. Refer
to the illustration below.
To light a burner, push in and turn the corresponding
control knob counterclockwise to the HIGH setting. You
will hear a clicking sound and see the burner ignite. Once
the burner is lit, continue turning the knob counterclock-
wise to any one of the settings, HIGH through LOW.
To select a SIMMER setting, turn the control knob to the
LOW setting. You will feel a stop detent in the knob
rotation. Push the knob in and continue turning it counter-
clockwise. This moves the flame to the second tier. Then
select any one of the SIMMER settings, HIGH through
LOW.
Each control knob is designed to be a push-to-turn knob.
Although this is a child-safe design, children should never
be left unattended in the kitchen when the range is in use.
FLAME HEIGHT AND APPEARANCE
Select a flame that is just high enough to maintain the
desired cooking speed and is sized to fit the base
diameter of the pan. Never extend the flame beyond the
base of the pan. Smaller diameter pans should be used on
the left rear burner.
A natural gas flame should be blue with a deeper blue
core. There should be minimal trace of a yellow flame. A
yellow flame indicates an improper mixture of air and gas
or impurities in the gas supply to the range. If this occurs
consistently, call Wolf factory certified service to adjust the
mixture. With LP gas, some yellow tipping to the flame is
acceptable and may not require adjustment.
A popping sound may be noticed with LP gas when the
surface burner is turned off. This is normal.
MANUAL LIGHTING
In case of a power outage, you can relight the surface
burners manually. Turn the control knob to HIGH, then
light each burner individually using a BBQ lighter.