Original operation manual
37
AirlessPhoenixGX_BA_en_1803 • 0550010-en • jw
Operation
CAUTION
If parts of the machine are clogged (e.g. spray nozzle, material
filter for the spray gun, material hose, high pressure filter, suction
strainer, etc.), the pressure can not completely escape. Material
can escape under high pressure when threaded connections are
released and injure you.
➤
Protect yourself against suddenly ejecting material by
covering threaded connections with a cloth while loosening
them.
➤
Loosen threaded connections particularly cautiously and
allow the pressure to escape slowly.
➤
Remove the blockages.
Observe the fault table (chap. 7 ‘Eliminating operational
faults’ on page 46).
6.
Remove the nozzle from the spray gun. Observe and follow the
information in the user manual for the spray gun.
7.
Remove the filter element from the high pressure filter
(see 6.4.1 ‘Cleaning the filter element’ on page 43).
8.
Remove the suction tube from the material drum. Scrape the
paint residue off the suction tube and strainer.
9.
Position the suction tube with strainer in the container with the
cleaning agent.
10.
Open the compressed air shut-off valve.
11.
Set a low working pressure on the compressed air regulator so
that the pump runs slowly.
12.
Open the relief valve on the high pressure filter until clean
cleaning agent runs out.
13.
Close the relief valve.
14.
Hold the spray gun sideways against the inner wall of the
collecting vessel.
15.
Trigger the gun until clean cleaning agent runs out.
16.
Close and lock the gun.
