Operational reliability of the installation is assured,
assuming that all guide lines were adhered to dur-
ing proper installation. The quality and function of
individual components are subject to thorough
inspection and is checked before dispatch from
our works. Once installation fitting is complete,
the lift car frame system should undergo an oper-
ational test before commissioning or before possi-
ble inspection from a technical institute.
First test run after installation
Before the first test run:
Clean the guide rails!
Clear all people and objects from the lift
shaft before commencing the test run
Risk of crushing injuries!
The entire lift travel path should be slowly trav-
elled (in inspection mode) before the functions
tests. Attention should be paid to the clearance of
all fastened parts, especially with regards to the
guide brackets/safety gear devices. Find and
remove any protruding bolts or other dangerous
restrictions well in advance.
Safety clearance inspections at the bottom of the
shaft and shaft head (observe the applicable regu-
lations/guidelines):
-
Check the following distances between the
shaft floor, after descending the shaft pas-
sage:
- Distance between guide - floor
- Distance between cross beam - floor
-
Check the following distances to the shaft
ceiling, on completion of ascension of the lift
shaft:
- Distance between guide - ceiling
- Distance between rope pulleys - ceiling
- Distance between cross beam - ceiling
Static & dynamic function testing
Refer to the operating instructions of the relevant
safety device.
Examine the lift car frame for changes
after carrying out the safety gear test:
- deformation of components
- that the screws are firmly in place
- signs of damage or wear on the rope
pulleys, guides and suspension points
There must not be anybody in the lift car
when carrying out test runs or functions
tests!
Car Frame WCS60
Suspension 2:1 / 4:1
Operating instructions
Änderungen vorbehalten!
Subject to change without notice!
3
Function testing
Blatt/
sheet
D389MGB.020
Datum/
date
11.02.2002
Stand/
version
11.02.2002
Geprüft/
approved
WAT/FLE
