Wintriss WPC 1000, User Manual

Page: 82 / 235

WPC 1000 User Manual 1125100
Installation 2-55
Installing the Display Cable
With your WPC 1000 mounting plate and panel mount display or display board kit, you
should have received a 34-conductor shielded ribbon cable (10’, 30’, or 100’) to connect the
WPC 1000 Control board to the Display board. There is a connector already installed on one
end of the cable. An extra connector is included for installation after the cable has been routed
through conduit.
Two types of ribbon cable are currently being provided. One cable, which is unshielded, has
conductors of various colors with brown and tan conductors at the edges (see Figure 2-31).
The other cable is shielded and has gray conductors except for a red conductor at one edge
(see Figure 2-39, page 2-61). Follow the procedure that pertains to the type of ribbon cable
you received with your order: Installing the Multicolored Ribbon Cable (next) or Installing
the Shielded Gray Ribbon Cable, page 2-60.
Installing the Multicolored Ribbon Cable
When wiring the ribbon cable to the extra connector, make sure that the orientation of the
brown and tan wires at the edges of the cable is identical to the orientation of the wires
attached to the installed connector (see Figure 2-31).
CONNECT DISPLAY CABLE CORRECTLY AT BOTH ENDS
After installing the display cable, check to make sure that connections are correct at both Control
and Display board ends. If the display cable is plugged into the ribbon cable connectors
incorrectly, your display may not work properly.
Figure 2-31. Multicolored Ribbon Cable with Connector
NOTICE
Ribbon cable
Connector
Brown wire
Purple wire
Key
Tan wire