Wintriss WPC 1000, User Manual

Page: 88 / 235

WPC 1000 User Manual 1125100
Installation 2-61
4.
Connect the ring lug on the end of the insulated shield (see Figure 2-39) to the standoff
beneath J104, using the hex nut that secures the board to the standoff.
5.
At the Display board end of the ribbon cable connection, cut the cable jacket at a point that
allows enough cable to make a comfortable connection at J706 on the WPC 1000 Display
board.
6.
Strip the black outer jacket from the end of the cable to expose about 4 in. of wiring, being
careful not to cut through the braided shield.
7.
Slide the braided shield over the foil-encased conductors toward the jacket until it bellies
outward, then with your index finger pry a hole in the base of the shield (i.e., at the edge of
the jacket) and draw the conductors through the hole until the shield wires have been
completely separated from the conductors.
8.
Remove the foil surrounding the conductors.
9.
Pull gently on the braided shield, twisting individual wires as necessary, to straighten it
and create a separate conductor (see Figure 2-40, page 2-62).
The ribbon cable connector can be plugged into the J104 connector in only one direction.
When inserting the plug, make sure to align the key in the plug (see Figure 2-39) with the
middle groove on the J104 connector. If the plug is not inserted correctly, the display will
not work properly.
Figure 2-39. Gray Ribbon Cable with Connector and Insulated Shield
NOTICE
Ribbon cable
Insulated shield
Ring lug
Connector
Red wire
Key