Wintriss Shadow VI, User Manual

Page: 60 / 159

1107200 Shadow VI User Manual
page 48 Chapter 2 Installation and Checkout
To connect a wire, find the correct terminal and loosen the screw over it by turning it
counterclockwise. Strip the correct wire for this terminal 1/4" (6.4 mm) from end. Insert
bare wire into the terminal 90% of the way. Tighten the screw. The metal tooth inside the
terminal will clamp down on the bare wire for a tight connection. Make sure that the
metal tooth is clamped down on the bare part of the wire, not on the insulation.
7. Once you have completed the wiring for the receiver, plug the L-shaped connector firmly
back into its base. It only can go in one way.
8. Now wire the transmitter. Remove the L-shaped connector from TB3 (upper level).
Attach the wires to this connector as shown in Table 2-4 at the end of this section. You
can also refer to Figure 1 at the end of this manual.
9. Once you have completed the wiring, plug the L-shaped connector firmly back into its
base. It only can go in one way.
10. Make sure you have properly connected all wires and have double checked all
connections when done.
Table 2-3. Connecting Light Curtain Receiver Head to TB2 in Controller
Set #1 Heads to Upper Level; Set #2 Heads to Lower Level
RCVR TB2 Wire color Terminal signal
Pin #1 orange FWIN
Pin #2 red VCC
Pin #3
blue
and
black
GND
Pin #4 brown 1B
Pin #5 green 1A
Pin #6 yellow SYNC
Terminate shield to set screw terminal near entry point.
(See “
Terminating Shields of the Head Cables
,” page 46.)