Winget Crocker RP1500XD, Parts & Operation Manual

Page: 20 / 122

MIXING STAR BLADES:
They are of a special shape and material to prolong wear life. They should not
be modified in any way and only replaced by genuine
‘WINGET CROKER’
spares.
Daily check is advised to ensure that the Blades/Wearing Pieces are securely
bolted and undamaged.
PAN RIM & BASE WEARING PLATES:
They must be replaced before excessive wear causes distortion.
MAXIMUM BATCH LOADS:
Under no circumstances should the Maximum Batch Loads quoted be
exceeded nor should the Mixer be stopped and re-started when there is a mix in
the Pan.
After each mix the contents of the pan must be completely discharged
before attempting to close the discharge door. At the end of each period of
operation the mixing pan, mixing blades, discharge blade and fingers,
discharge chute, discharge door and seating must be washed down to
prevent concrete setting on them and so impairing the efficiency of the
machine.
WARNING:
THE MAUFACTURER ACCEPTS NO RESPONSIBILITY FOR ANY
DAMAGE OR FAILURE RESULTING FROM OPERATIONAL MIS-
USE OR MALPRACTICE.
OPERATING INSTRUCTIONS FOR WEIGH GEAR
MECHANISM
HYDROSTATIC LOADCELL & GAUGE
The Hydrostatic Load Cell is connected by a flexible capillary tube (approx 9.7
metres long) to a 300mm (12”) diameter weigh gauge.
The whole system is assembled and filled with fluid under vacuum and under
no circumstances should any of the components be disconnected, in the event
of component damage the complete assembly should be returned to Winget
Limited for repair.