44
Chronosonic
XVX
Inst allation Guide
s
e C t I o n
4� 3 —r
e M oV I n G
t h e
P
ro t e C t I V e
f
I l M
45
W i l s o n A u d i o S p e c i a l t i e s
A u t h e n t i c E x c e l l e n c e
™
the caster), use the swivel caster wrench to loosen the casters.
Remove the casters.
4. Insert and screw-in the finished spike assembly. Hand tighten
only!
Note: Be very careful not to cross-thread the spikes. The base of the Chro-
nosonic XVX is made of “X” material and can be cross threaded if installed
on an angle.
5. With one person stabilizing the Chronosonic XVX, lower the
Chronosonic XVX by turning the jack wrench counterclockwise.
Note that the Chronosonic XVX will now sit lower in the front
as the spike assembly is shorter than the caster. Use caution.
Note: It is very important, at this point, that an able assistant stabilize the
front of the Chronosonic XVX until the rear spikes are attached and the
unit is lowered.
6. Repeat the previous process of the caster removal/spike inser-
tion on the opposite side of the enclosure. Then continue the
process on the other channel.
Leveling the Chronosonic XVX
1. It is not necessary to use the jack to level the Chronosonic XVX.
2. There is precision bubble level installed on the rear of the up-
per Micrometer. Use this level to determine the loudspeaker’s
level.
3. If the level is anywhere but in the general area of the center of
the inscribed circle, proceed to the next step.
4. If the bubble shows that the speaker is leaning toward the
center of the room, you will have to lengthen one of the inside
spikes down toward the floor. If the bubble is leaning toward
the outside of the room, you will have to lengthen one of the
outside spikes down toward the floor.
5. Have an assistant tip the Chronosonic away from the spike in
question. Lengthen the spike accordingly.
6. To find out which spike to lower, grasp the Chronosonic XVX
channel and rock it back and forth. This will identify the spike
that is out of level from the other three.
Place a level on the front to back oriented axis. If it is level, then your
Chronosonic XVX’s are level. Using the same process as above, adjust the front
or rear spikes to achieve front to back level.
Section 4.3—Removing the Protective Film
To protect the finish of the Chronosonic XVX during final manufacture,
System Level
Summary of Contents for Chronosonic XVX
