Wilan VIP 110-24, Operator'S Manual

Page: 70 / 101

VIP 110-24 Operator’s Manual (rev E)
- 63 -
>run vip01_04
set-default-program
filename=filename
Sets the specified file as the default program to be loaded upon reboot or power cycle. Since
the default program must reside in flash memory, the “flash/” prefix is assumed and is not
required for the command.
Examples:
>set-default-program vip01_04
6.10 Miscellaneous commands
date
The VIP 110-24 will set the internal radio date and time automatically by decoding Network
Time Protocol (NTP) packets in the Ethernet LAN. The “zone” parameter specified with the
“date” or “time” command will then be used to display the date/time in local time. The “zone”
value is saved as part of the radio configuration.
If NTP packets are not available, the user can initialize the radio date and time with either the
“date” or “time” commands. The parameters for both commands are identical, but the
parameter order is different. The date command can be entered as:
> date 16-may-2000 10:32:06
date=day-month-year
Sets the date used by the radio. The day / month / year parameter may be separated by any
valid separator (‘-‘ ‘/’ etc.)
time=hh:mm:ss
Sets the radio time in hours, minutes and seconds. Use colons to separate the three fields.
zone=zone-code or offset
Sets the time zone to be used by the radio to translate the NTP time to local time. It can be
specified by an offset from GMT (-0800 or +0200 for example), or as a “zone-code”. The valid
“zone-codes” and the respective offsets are shown below: