Wilan VIP 110-24, Operator'S Manual

Page: 53 / 101

VIP 110-24 Operator’s Manual (rev E)
- 46 -
display-configuration
source= current or main or alternate or factory
Displays all the parameter values for the specified configuration. If the source is not specified
it defaults to “current”. A sample output is shown below.
---------------------------------------------------------------------------
NODE Name: Bank Network ID: 42
Type: Leaf Location: Wall Street
Anchor: No Contact: Greenspan
---------------------------------------------------------------------------
IP Address: 207.154.90.81 | SNMP Manager Community Access
Netmask: 255.255.255.0 | 1 207.154.103.12 public g
Gateway: 207.154.90.1 | 2 207.154.103.18 public gst
| 3
Time Zone: PST | 4
--------------------------------+------------------------------------------
FLOW RATES(kbps): TX RX | RF-LINKS: Ch Spd Pwr Ant
Minimum 10 10 | * To Parent: 11 23 A
Maximum 10000 10000 | * From Parent: 5 11 23 A
| From Children: 25 B
Max Cycle (ms): 100 | NN Poll 1: 5 18 B
Max Bytes/cycle: 76000 | NN Poll 2: 35 18 B
--------------------------------+------------------------------------------
ETHERNET | Single Node Reboot Timeout (sec): 900
Station t/o (sec): 30 | Antenna Alignment Aid: Off
Multicast t/o (sec): 600 |
Speed: Auto (10 FD) | EVENT-LOG-LEVELS - Print: 3 Save: 5
A few notes about this display:
1. The Network ID field is only displayed if the configuration is unlocked. Otherwise it will
be blank.
2. The “asterisks” in the RF-LINKS field indicate which links are active for the current
configuration. In the example above, since the radio is configured as a “leaf”, only the
links “to” and “from” the parent are relevant.
The following table maps the parameters displayed to the command that is used to change those
parameters. Refer to the command for additional information about those parameters.
Examples:
> display-configuration source=current
> discon