Wilan VIP 110-24, Operator'S Manual

Page: 67 / 101

VIP 110-24 Operator’s Manual (rev E)
- 60 -
clear-log
region= all-events or reboot-reasons
This command clears the contents of the system event log from the specified “region”. After a
code upgrade it is recommended to clear the reboot reasons since the pointer in non-volatile
memory pointing to the reason message may no longer be valid.
display-log
region=end or beginning or all-events or reboot-reasons
length=1..500
id=0..200
min-level=0..7
max-level=0..7
This command outputs to the terminal the specified “region” of the event log. The “length”
parameter specifies the number of events to output (defaults to 10). The remaining parameters
provide filters to leave out specific events. If the “id” parameter is specified, only the event
identified by that id will be displayed. The “min-level” and “max-level” settings allow the user
to display only the events with the specified category range.
The “reboot-reasons” region of the event log consist of the last four events that that caused the
radio to reboot. These events are stored in non-volatile memory. The time tag in these events
is the time the radio was up since it was rebooted, not the time of day.
Examples:
>display-log region=all
>display-log region=all length=300 min-level=2 max-level=6
max-event
Sets the event severity level that should be saved or displayed. These two parameters are saved
as part of the configuration
save=0..7
Only events of the specified level or below will be saved in the event log.
print=0..7
Events of the specified level or below will be output to the terminal as they occur.
Examples:
>max-event print=6
6.9 File Utilities
The VIP 110-24 maintains a file system that allows multiple programs to be stored in either non-
volatile flash PROM or volatile RAM. New programs can be downloaded into the VIP110-24