40
6 Set up with the display and adjustment module
WIKA Operating Instructions - Process pressure transmitter CPT-2x
The default setting for the display format is "
Automatic
".
The display and adjustment module has a backlight for the display.
In this menu item you can switch on the lighting. You can find the
required operating voltage in chapter "
Technical data
".
In delivery status, the lighting is switched on.
6.5.3 Diagnostics
In this menu item, the device status is displayed.
In case of error, e.g. the error code F017, e.g. the error description
"
Adjustment span too small
" and a four digit figure are displayed for
service purposes. You can find the error codes with description, rea
-
son as well as rectification in chapter "
Asset Management
".
The respective min. and max. measured values are saved in the
sensor. The two values are displayed in menu item "
Peak values,
pressure
".
In another window you can carry out a reset of the peak values
separately.
The respective min. and max. measured values of the measuring cell
and the electronics temperature are stored in the sensor. In menu
item "
Peak value, temperature
", both values are displayed.
In another window you can carry out a reset of the two peak values
separately.
In this menu item you simulate measured values. Hence, the signal
path can be tested via the bus system to the input card of the control
system.
Backlight
Sensor status
Peak value, pressure
Peak value, temperature
Simulation
