8. Remote Operation
WIKA Operating Instruction High Pressure Controller, Model CPC8000-H
69
GB
1
42
3
59
9
3
.0
0/
0
6/2
0
17
/GB
8.4 SCPI Command Set
Table 9 SCPI
–
WIKA Befehlssatz
Item
Command or Query
Response/Function
STATus
:OPERation
1.
:CONDition?
Returns an integer value representing instrument status
that can be decoded.
Bit 0: Zeroing active.
Bit 1: Control Setpoint has not been reached.
Bit 2: Reserved 0.
Bit 3: Reserved 0.
Bit 4: Measuring. The instrument is actively measuring.
MEASure
2.
[:PRESsure] [z]?
Returns the pressure in the current units from the specified
sensor, or active sensor if [z] is omitted.
3.
:TEMPerature[z]?
Returns the temperature in deg. C. from the specified
sensor, or active sensor if [z] is omitted.
4.
:RATE[z]?
Returns the pressure rate in the current units from the
specified sensor, or active sensor if [z] is omitted.
5.
:BAROmetric?
Returns the barometric pressure in the current unit, if a
barometer sensor is installed.
CALibration
6.
[:PRESsure] [z]
7.
:MODE?
Returns 1 if the sensor has been calibrated or 0 if not.
8.
:DATE?
Returns the stored calibration date.
9.
:DATE <i,i,i>
Sets the calibration date (YYYY,MM,DD).
10.
:ZERO?
Returns current zero point correction in bar.
11.
:ZERO <n>
Sets the zero so the currently measured pressure matches
the commanded value in the current unit. Limited to +/-5%
FS.
12.
:ZERO:RUN
Vents the instrument and sets zero so the currently
measured pressure = 0.
13.
:ZERO:STOP
14.
:ZERO:INITiate
15.
:ZERO:INITiate?
